3-4 Battery Charger
MX3-CE Reference Guide E-EQ-MX3CERG-A-ARC
The NiCd backup battery should be discharged completely once or twice a year. The Main Battery
Pack will fully charge the backup battery. This process will allow longer life for the Backup
Battery.
The backup battery is discharged by selecting Control Panel / Power Properties / Battery and
clicking the "Discharge" button. The discharge utility shows the progress of the discharging. At
this time, the program can be exited while continuing the discharge process. Normal use of the
MX3-CE can resume during the discharge, with the exception of Hot-Swapping the Main Battery.
When the backup battery is fully discharged, the MX3-CE will automatically stop the discharge
process and begin to recharge the backup battery.
DO NOT REMOVE THE MAIN BATTERY PACK from the MX3-CE until the backup battery is
completely discharged -- in approximately 1 hour and recharged in approximately 2.5 hours.
Battery Charger
Figure 3-2 LXE Multi-Charger
The MX3-CE Main Battery Pack can be charged in the LXE Multi-Charger.
Figure 3-3 Insert Main Battery in Charger
Lower the battery pack straight into the battery charger pocket and push it down firmly until the
retaining clip catches on the retaining pins.
Do not "slam" the battery into the charging cup or slide it in sideways.
Failure to follow these instructions can result in damage to the main battery or the charger.
Please refer to the "LXE Multi-Charger Operator's Guide" for technical information and
operating instructions.
