Reflash the MX3-CE C-11
E-EQ-MX3CERG-A-ARC MX3-CE Reference Guide
Reflash the MX3-CE
How To
1. Remove the endcap from the MX3-CE being very careful not to damage the leads to the
external power jack, the headphone jack or the antenna. The antenna may be taped to the
endcap so great care must be taken when removing the endcap.
2. Place the compact flash card labeled BOOT.BIN in the right hand slot.
3. Power cycle the computer. This is accomplished by holding the power key down for 15
seconds.
4. When the display switches off release the power key. The computer automatically loads the
new boot loader and programs the flash. This will take approximately 5 seconds.
5. When the computer displays "Done, Reboot" remove the flash card and the computer will
reboot.
6. Place the compact flash card labeled NK.BIN in the right hand slot.
7. Power cycle the computer. This is accomplished by holding the power key down for 15
seconds.
8. When the display switches off release the power key. The computer automatically loads the
new CE image and programs the flash. This will take approximately 2 minutes.
9. When the computer displays "Done, Reboot" remove the flash card and the computer will
reboot.
10. Replace the endcap, being careful not to pinch any leads.
