E-EQ-MX3CERG-A-ARC MX3-CE Reference Guide
Chapter 5 RF Network Configuration
Introduction
Change the radio parameters by editing the Wireless parameters in the Control Panel.
Lucent Parameters
The following are the parameters that can be accessed and modified using the Task Bar Lucent
icon for computers with Lucent 2.4GHz radios.
• Describes current connection data : Client, Network, Connection, AP, Channel,
Encryption and SNR graph.
• Using the Tools menu, the user can check version information of the software. The
options Load and Unload Automatically and Suspend While Connected can be toggled
on or off using the Tools menu.
• Selecting Edit Wireless Profiles at the Tools Menu begins the editing session described
in Chapter 4 "System Configuration", section "Wireless".
The following are the parameters that can be modified in the Control Panel Wireless option for
computers with Lucent 2.4GHz radios.
WaveLAN Network Name
Identifies the WaveLAN network the station will connect to.
Valid: 0 to 32 string of printable uppercase characters.
Default: ANY
Note: Setting this value to ANY will enable the station to connect to any IEEE 802.11 network.
Note: The string for WaveLAN_Network_Name is case-sensitive. The WaveLAN DOS ODI
driver requires the use of only UPPERCASE characters. If you have configured the
Access Points with lower-case names you will need to change your Access Point
WaveLAN_Network_Name parameter to UPPERCASE characters for proper operation.
Or, place double quotes around the WaveLAN_Network_Name to allow proper operation
with upper and lower case letters e.g. "NameofUnit".
