A SERVICE OF

logo

Scanner Parameters 6-29
E-EQ-MX3CERG-A-ARC MX3-CE Reference Guide
Code 93
Parameter Default Value: Disable
When enabled, Code 93 symbols will be scanned, decoded and transmitted.
Set this parameter by scanning either of the barcodes shown below.
Enable
Enable Code 93
Disable
Disable Code 93
Set Lengths for Code 93
L1 Parameter Default Value: 4
L2 Parameter Default Value: 55
Lengths for Code 93 may be set for:
any length,
one or two discrete lengths,
or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains.
See the table titled “ASCII Character Equivalents” at the end of this chapter.