Scanner Parameters 6-47
E-EQ-MX3CERG-A-ARC MX3-CE Reference Guide
Two Discrete Lengths (Parameter L2)
This option decodes only those codes containing two selected lengths. For example, when you
want to scan only I 2 of 5 symbols containing 2 or 14 characters, scan the “I 2 of 5 Two Discrete
Lengths” barcode and then “0”, “2”, “1” and “4” barcodes using the “Keypad Number Symbols” at
the end of this chapter.
To begin setting two discrete lengths, scan this barcode:
I 2 of 5 - Two Discrete Lengths
Next, scan four numeric barcodes that correspond to the desired value. Single digit numbers must
have a leading zero. If you wish to change your number selection, scan Cancel on the “Keypad
Number Symbols” page.
Length Within Range
This option decodes a code type within a specified minimum and maximum range. For example,
when you want to scan only I 2 of 5 symbols containing between 4 and 12 characters, scan the “I 2
of 5 Length Within Range” barcode and then “0”, “4”, “1” and “2” barcodes using the “Keypad
Number Symbols” at the end of this chapter.
To begin setting lengths within a range, scan this barcode:
I 2 of 5 - Length within Range
Next, scan numeric barcodes that correspond to the desired value. Single digit numbers must have
a leading zero. If you wish to change your number selection, scan Cancel on the “Keypad Number
Symbols” page.
Any Length
This option decodes I 2 of 5 barcodes containing any number of characters.
Note: Selecting this option may lead to misdecodes for I 2 of 5 codes.
To set any length, scan this barcode:
I 2 of 5 - Any Length
