Getting Started 1-5
E-EQ-MX3CERG-A-ARC MX3-CE Reference Guide
Getting Started
Note: When your MX3-CE is pre-configured, the radio, PCMCIA card and endcaps are
assembled by LXE to your specifications.
This section’s instructions are based on the assumption that your new system is pre-configured and
requires only accessory installation (e.g. handstrap, stylus) and a power source. LXE recommends
that installation or removal of accessories be performed on a clean, well-lit surface. When
necessary, protect the work surface, MX3-CE, and components from electrostatic discharge.
Figure 1-4 Hardware Configuration
Use this guide as you would any other source book -- reading portions to learn about the MX3-CE,
and then referring to it when you need more information about a particular subject. This guide
takes you through an introduction to and operation of the LXE MX3-CE.
In general, the sequence of events is:
1. Insert a fully charged battery and the unit automatically turns on.
2. Connect an external power source to the unit (if required).
3. Adjust screen display, audio volume and other parameters if desired.
Note: New batteries must be fully charged prior to use. This process takes up to four hours in
an LXE Multi-Charger and up to eight hours using the MX3-CE internal charger.
Refer to the documentation received with the charger for complete information.
