A SERVICE OF

logo

Open as PDF
next previous
Scanner Parameters 6-49
E-EQ-MX3CERG-A-ARC MX3-CE Reference Guide
Laser On Time
Parameter Default Value: 3.0 Seconds
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. If a label has not been decoded
before this time expires and the session is terminated, the system regards it as a failed scan attempt.
To begin setting Laser On Time, scan this barcode:
Laser On Time
Next, scan two numeric barcodes that correspond to the desired on time using the “Keypad
Number Symbols” at the end of this chapter. Times less than 1.0 second must have a leading zero.
If you wish to change your number selection, scan Cancel on the “Keypad Number Symbols” page.