E-EQ-MX3CERG-A-ARC MX3-CE Reference Guide
Chapter 6 SE923 Scanner
Barcodes must be printed on a 600dpi printer.
The barcodes cannot be scanned online.
This chapter’s explanations and instructions are directed toward the SE923 scanner endcap. DO
NOT USE THE BARCODES IN THIS CHAPTER FOR ANY OTHER SCANNER ENDCAP.
Introduction
Read all cautions, warnings and labels before using the scanner
endcaps.
The MX3-CE Barcode Scanner is used to collect barcoded data from any nearby compatible
barcode label. The directions in this chapter are directed toward the LXE scanner model SE-923
parameter setup.
See Chapter 1 “Introduction” for descriptions of endcap configurations.
Note: Do not disable “Parameter Scanning” in the MX3-CE until all parameters have been set.
Quick Start
This section’s instructions are abbreviated and based on the assumption that your MX3-CE will
power up.
• Install a fully charged battery in the MX3-CE.
• Configure the decoder using the barcodes in the “System Setup” section of this chapter,
if necessary. “System Setup” has the most commonly used parameters at the beginning
of the section.
• Scan a barcode.
