Filter
Top Products
Groundsmaster 5910Operator Cab Page 9 -- 10
Air Conditioning Condenser Assembly
1. Condenser cover
2. Flange nut (4 used)
3. Condenser fan
4. Condenser coil assembly
5. Flange nut (2 used)
6. Flat washer (4 used)
7. Roof
8. Bushing (4 used)
9. Flange head screw (2 used)
Figure 7
2
1
3
4
7
8
6
5
9
6
Removal (Fig. 7)
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Remove fasteners that secure roof in place. Raise
and supportroofto allow access to condenser assembly
(see Roof Assembly Removal in this section).
3. Disconnect wire harness connector from condenser
fan motor.
4. Remove flange nuts (item 2) that secure condenser
fan and cover to condenser coil.
5. Remove fasteners (items 5, 6, 8 and 9) that secure
condenser cover to roof. Lift cover and condenser fan
from roof.
6. Read the General Precautions for Removing and
Installing Air Conditioning System Components at the
beginning of the Service and Repairs section of this
chapter.
CAUTION
The air conditioning system is under high pres-
sure. Do not loosen any system fitting or compo-
nent until after the system has been completely
discharged by a certified A/C service technician.
7. Have refrigerant evacuated from air conditioning
system by a certified A/C service technician.