Filter
Top Products
Groundsmaster 5900/5910 Page 5 -- 31 Electrical System
Traction Pedal Teach
1. Remove the power center console located to the
right of the operator seat.
2. Locate wire harness termination cap that connects
the two (2) traction pedal Teach wires (Fig. 53).
3. Remove termination cap and connect the two (2)
Teach wires together (Fig. 54).
4. Turn ignition switch to ON but do not start engine.
The Info Center Display will be in the “Teach Mode.” Fol-
low the screen prompts to calibrate the traction poten-
tiometer valves to the TEC--5002 controller.
5. After calibration is complete, turn ignition switch to
OFF. Separate the two (2) Teach wires and connect the
wire harness termination cap to the wires.
6. Install and secure power center console.
1. Male teach wire
2. Female teach wire
3. Termination cap
Figure 53
1
2
3
1. Male teach wire 2. Female teach wire
Figure 54
1
2
Electrical
System