Filter
Top Products
Groundsmaster 5900/5910Cutting Decks Page 8 -- 20
Deck Skids and Rollers
Removal (Fig. 20 and 21)
1. Remove skids and rollers from deck using Figures
20 and 21 as guides.
Installation (Fig. 20 and 21)
1. Install skids and rollers to deck using Figures 20 and
21 as guides.
A. Make sure to install skids (item 7) in the same
mounting hole height position (lower, middle or up-
per).
B. Makesure to install all deckr ollers (items2and9)
in the same mounting hole height position (lower or
upper).
C. When installing roller (item 2) on the front deck
winglets (Fig. 20), install cap screw with the threads
orientated toward the centerline of the deck. Install
and tighten lock nut so that nylon locking insert in nut
is fully engaged by bolt threads and roller rotates
freely.
D. When installing roller (item 2) on a wing deck (Fig.
21), install cap screw with the threads orientated
away from the centerline of the machine. Install and
tighten lock nut so that nylon locking insert in nut is
fully engagedby boltthreadsandrollerrotatesfreely.
1. Cap screw
2. Roller
3. Lock nut
4. Washer head screw
5. Carriage screw
6. Flange nut
7. Bumper skid (2 used)
8. Carriage screw
9. Roller
10. Roller shaft
11. Flange nut
Figure 20
FRONT DECK
9
1
11
6
12
10
7
3
4
5
8
2
1
3
2
80 to 100 in--lb
(9.0 to 11.3 N--m)
FRONT
RIGHT
1. Lock nut
2. Roller
3. Cap screw
4. Washer head screw
5. Carriage screw
6. Flange nut
7. Bumper skid
Figure 21
WING DECK (RH SHOWN)
1
6
7
3
4
5
8
2
3
2
1
7
80 to 100 in--lb
(9.0 to 11.3 N--m)
FRONT
RIGHT