Filter
Top Products
Groundsmaster 5900/5910Page 5 -- 14Electrical System
5. The FOR TRACTION ASSIST advisory identifies
that the the traction assist system will not engage when
the traction assist switch is pressed (Fig. 14).
A. SEAT OPERATOR. Operator needs to be in seat
to engage traction assist.
B. MUST BE IN LOW RANGE. Machine is set to
high speed range and needs to be in low speed to en-
gage traction assist.
6. The TO ENGAGE PTO advisory identifies that the
PTO will not engage when the PTO switch is pulled out
(Fig. 15):
A. SEAT OPERATOR. Operator needs to be in seat
to engage PTO.
B. MUST BE IN LOW RANGE. Machine is set to
high speed range and needs to be in low speed be-
fore PTO will engage.
C. LET ENGINE WARM. Engine needs to reach op-
erating temperature before PTO will engage.
D. LOWER DECKS. No cutting decks are lowered.
At least one deck must be fully lowered before the
PTO will engage.
E. SOLVE ENGINE TORQUE LIMIT. Engine torque
is limited.
7. The TO SET CRUISE CONTROL advisory identifies
that the cruise control will not engage when the cruise
control switch is pressed (Fig. 16):
A. INCREASE TRACTION. Forward ground speed
is too low to engage cruise control.
8. The TO FLOAT DECK advisory identifies that the
cutting decks are not in float mode (Fig. 17):
A. LOWER DECKS. Press deck lower switch(es) to
fully lower the decks and engage the float position.
Figure 14
A
B
Figure 15
A
B
C
D
E
Figure 16
A
Figure 17
A