Filter
Top Products
58 Chapter 2
Basic Operation
Using Data Storage Functions
2. Press Save > SelectSeq.
The sequence number becomes the active function. The signal generator displays the last sequence
used. Using the arrow keys, set the sequence to 1.
3. Press
SelectReg.
The register number in sequence 1 becomes the active function. The signal generator displays
either the last register used accompanied by the text: (in use), or (if no registers are in use)
register 00 accompanied by the text: (available). Use the arrow keys to select register 01.
4. Press
Save Seq[1] Reg[01].
This saves this instrument state in sequence 1, register 01 of the instrument state register.
5. Press
Add Comment to Seq[1] Reg[01].
This enables you to add a descriptive comment to sequence 1 register 01.
6. Using the alphanumeric softkeys or the knob, enter a comment and press
Enter.
7. Press
Edit Comment In Seq[1] Reg[01].
If you wish, you can now change the descriptive comment for sequence 1 register 01.
After making changes to an instrument state, you can save it back to a specific register by
highlighting that register and pressing Re-SAVE Seq[n] Reg[nn].
Recalling an Instrument State
Using this procedure, you will learn how to recall instrument settings saved to an instrument state
register.
1. Press
Preset.
2. Press the
Recall hardkey.
Notice that the
SelectSeq softkey shows sequence 1. (This is the last sequence that you used.)
3. Press
RECALL Reg.
The register to be recalled in sequence 1 becomes the active function. Press the up arrow key
once to select register 1. Your stored instrument state settings should have been recalled.
Deleting Registers and Sequences
These procedures describe how to delete registers and sequences saved to an instrument state
register.
Deleting a Specific Register within a Sequence
1. Press
Preset.
2. Press the
Recall or Save hardkey.
Notice that the
SelectSeq softkey shows the last sequence that you used.
3. Press
Select Seq and enter the sequence number containing the register you want to delete.