LXE E-EQ-VX5RG-G-ARC Manual

A SERVICE OF

next previous

182 Cisco Radio

VX5 Reference Guide E-EQ-VX5RG-G-ARC

PEAP/GTC Configuration

To configure PEAP/GTC (Cisco PEAP) the Cisco PEAP supplicant must be installed. See

“installing Radio Drivers” earlier in this chapter to check for the Cisco PEAP supplicant and

install if required. This supplicant is from Cisco and licensed to be used only with a Cisco radio.

Configuring the PEAP/GTC Supplicant

Even though the Cisco tools (ACU) are installed, the Microsoft supplicant is used to configure the

radio parameters. The Cisco ACU must be configured to allow the Microsoft configuration tools

to set the wireless network settings.

Open the Cisco ACU and click the Set profile button.

Click the Use Another Application to Configure My Wireless Settings button.

Figure 4-73 Cisco ACU Profile Selection Screen

Click OK.

Configure the Wireless settings per “Wireless Network Configuration”, earlier in this chapter.