Cisco Radio 171
E-EQ-VX5RG-G-ARC VX5 Reference Guide
Installing Radio drivers
How much of the LXE released Cisco drivers/tools should be installed depends on what
authentication protocol is to be configured.
• Cisco PEAP should not be installed if using PEAP/MSCHAP.
• Cisco PEAP must be installed if using PEAP/GTC.
• For all other authentications (LEAP, EAP-TLS, WPA-PSK) it does not matter if
Cisco PEAP is installed or not.
To determine if Cisco PEAP is installed or to change the installation, follow the instructions
below.
Checking for the Cisco PEAP Supplicant
With a Cisco radio installed open the Wireless network properties as described in “Wireless
Network Configuration”, earlier in this chapter. With the Authentication tab selected check the
text in the EAP type drop down box. Refer to the following figures to determine if Cisco PEAP is
installed.
Cisco PEAP Not Installed
Cisco PEAP Installed
Figure 4-54 Determining Cisco Installed Components
If the Cisco installation is correct, continue with the authentication configuration. If it is not
correct, continue with the next section.
