Filter
Top Products
Using in Scope Mode 5 - 23
Using the ScopeRecord™ function
Before you start the ScopeRecord, make the following
preparations:
1. Determine whether you need a single ScopeRecord
that stops when the record memory is full (SINGLE
SWEEP), or a continuous ScopeRecord that stops only
by pressing .
To make this selection, do the following:
(a) From the Min Max Record menu, press
(MORE) to open the menu.
(b) Use to highlight TRACE REPEAT; then
press to select.
(c) Highlight the desired option; then press to
select.
2. Use to set the appropriate range for the
expected signal. During ScopeRecord, the test tool
maintains the present range.
3. Use to set the best time base in the range
from 20 ms/DIV to 60 s/DIV. During ScopeRecord the
test tool maintains the present time base.
Do the following to start a ScopeRecord:
1. From the Min Max Record menu press (START).
2. If there is still data in memory from the previous
recording, a message appears asking you to confirm
that you want to start recording.
NOTE
Starting a recording overwrites data stored from the
previous recording.
Press (YES) to start the ScopeRecord.
Press (NO) to cancel the ScopeRecord function.
3. To stop ScopeRecord, press .
Use the menu on the bottom display to examine the
results, as described in the next section starting with
step 2.