Filter
Top Products
Getting Started 2 - 11
If you have not already done so perform a + reset.
1. Activate the Scope Mode, then press . An image of the waveform appears on the
display. The top display shows the attenuator, probe, time base, and trigger information.
2. The waveform amplitude decreases. The attenuator scale in the top display changes to a less
sensitive range.
3. The number of periods of the waveform increases. The time base scale in the top display
changes to a slower time/DIV.
4. The waveform shifts upwards.
5. The waveform shifts to the right of the display.
Input A
Input A
Continued on next page
PERFORMING SOME SCOPE OPERATIONS