Filter
Top Products
Using Additional Capabilities 6 - 23
The items shown in this window are divided into three
pages. Select a page with (PREVIOUS PAGE) or
(NEXT PAGE).
2. The first page in the window defines some basic actions
taken during Auto Set. Specify whether the Continuous
Auto Set will optimize trigger source and trigger slope
during measurement. The factory default is "auto". Also
specify whether Auto Set will reset trigger delay (default
is that any delay set will be turned off).
3. The second page defines the input setup or items that
are turned off when the Continuous Auto Set is active.
A B SEPARATION (Default is auto: both waveforms
appear, separated by two divisions).
A B COUPLING (Default is DC: both inputs are DC
coupled).
TURN OFF AVERAGING (Default is yes: smooth
function is turned off).
TURN OFF X-MOVE (Default is yes: waveform in
center of the display).
TURN OFF Y-MOVE (Default is yes: waveform in
center of the display).
TURN OFF A versus B (Default is yes: A vs B function
is turned off).
4. The third page defines functions that are turned off
when the Continuous Auto Set is active.
TURN OFF CURSORS (Default is no : Cursors are not
turned off).
TURN OFF MATHEMATICS (Default is yes : Mathe-
matic function is turned off).
TURN OFF GENERATOR (Default is no : Generator is
not turned off).
TURN OFF DOT JOIN (Default is no : Dot Join remains
active).