Filter
Top Products
Getting Started 2 - 9
If you have not already done so, perform a + reset.
1. The range increases and ranging is set to MANUAL. A Vrms AC and a V DC reading appear,
and the amplitude of the graphical representation decreases.
2. Press this key once to measure a stable display. TOUCH HOLD appears in the top right of
the display.
3. Press this key once again to resume new measurements.
4. Press this key. The range decreases. If the voltage readings are overloaded, "OL Vrms AC"
and "+OL V DC" appear.
5. The test tool automatically assumes a new setup that is optimized for measuring the actual
input signal.
Input A
Input A
Continued on next page
PERFORMING SOME METER OPERATIONS