Filter
Top Products
TDS 310, TDS 320 & TDS 350 Programmer Manual
2Ć11
Command Groups
This section lists commands by functional groups. The following section,
Command Descriptions, lists commands alphabetically. The alphabetical list
starts on page 2Ć27.
The oscilloscope GPIB and RS232 interfaces conform to Tektronix standard
codes and formats except where noted. The GPIB interface also conforms to
IEEE Std 488.2-1987 except where noted.
Acquisition commands affect the acquisition of waveforms. These commands
control mode, averaging, enveloping, and singleĆwaveform acquisition.
TableĂ2Ć4:ăAcquisition Commands
Header
Description
ACQuire? Return acquisition parameters
ACQuire:MODe Acquisition mode
ACQuire:NUMACq? Return # of acquisitions obtained
ACQuire:NUMAVg Number of acquisitions for average
ACQuire:NUMEnv Number of acquisitions for envelope
ACQuire:STATE Start or stop acquisition system
ACQuire:STOPAfter Acquisition control
Alias commands let you define your own commands as a sequence of stanĆ
dard commands. This is useful when you use the same commands each time
you perform a certain task, such as setting up the oscilloscope to take a
measurement.
TableĂ2Ć5:ăAlias Commands
Header
Description
ALIas Turn the alias state on and off
ALIas:CATalog? Return a list of aliases
ALIas:DEFINE Create a new alias
ALIas:DELEte Remove an alias
Acquisition
Commands
Alias Commands