Filter
Top Products
3 - Configuration
40
The Agilent MCCD is shipped from the factory without a password being set. A network Password can
be assigned to the Agilent E4370A MCCD to prevent unauthorized users from controlling the unit over
the network. This is the same password that must be used when programming the Agilent MCCD using
the API functions.
Identification Configuration
In the Initial Screen, select 2 to configure the identification of your Agilent MCCD. The information in
this screen is for identification only. It is especially helpful when there are multiple Agilent MCCDs on
the LAN. Fill in the Identification Configuration screen as follows:
Select 1, 2, or 3, to enter the unit name, location or other unit identification.
Unit Name is the network name assigned to the Agilent MCCD. The name must begin with a letter and
end with either a letter or a number. Other characters in the name are limited to letters, numbers, periods,
or hyphens.
Unit Location identifies the physical location of the Agilent MCCD. Only printable ASCII characters are
allowed.
Other ID is any additional information that is required to identify this Agilent MCCD. Only printable
ASCII characters are allowed. This could be used for the asset number, department name, production
line, or other type of identification.
Identification Configuration
Unit Name MyName
Unit Location Third on left
Other ID Identification000.000
1) To change Unit Name
2) To change Unit Location
3) To change Other ID
Type a number and press Enter or ctrl-G to return to initial screen