Filter
Top Products
Getting Started
1Ć14
Example 2: Multiple Waveforms
In this example you learn how to display and control more than one waveĆ
form at a time.
The VERTICAL section of the front panel contains the channel selection
buttons. These are CH 1, CH 2, CH 3, CH 4, and MORE (Figure 1Ć13); on
the TDS 620A, they are CH 1, CH 2, AUX 1, AUX 2, and MORE.
Figure 1Ć13:ăThe Channel Buttons and Lights
Each of the channel (CH) buttons has a light above its label. Right now, the
CH 1 light is on. That light indicates that the vertical controls are set to
adjust channel 1.
The following steps add a waveform to the display.
1. If you are not continuing from the previous example, follow the instrucĆ
tions on page 1Ć7 under the heading Setting Up for the Examples.
2. Press SETUP ➞ Recall Factory Setup (main) ➞ OK Confirm Factory
Init (side).
Adding a Waveform