Filter
Top Products
Command Descriptions
TDS 310, TDS 320 & TDS 350 Programmer Manual
2Ć117
MEASUrement:MEAS<x>:STATE
Controls the measurement system. The source specified by MEASUreĆ
ment:MEAS<x>:SOUrce1 must be selected for the measurement to be
displayed. The source is selected using the SELect:CH<x> command.
Measurement
MEASUrement:MEAS<x>:STATE { OFF | ON | <NR1> }
MEASUrement:MEAS<x>:STATE?
MEAS
::MEASUrement
STATE
<x>
<Space>
OFF
?
ON
<NR1>
OFF or <NR1> = 0 turns measurements off. You can also turn the state off by
deselecting the source.
ON or <NR1> 0 turns measurements on.
MEASUREMENT:MEAS1:STATE ON
turns measurement defined as MEAS1 on.
MEASUREMENT:MEAS4:STATE?
returns either 0 or 1, indicating the state of MEAS4.
MEASUrement:MEAS<x>:TYPe
Sets or queries the measurement type for the measurement specified by
<x>. This is equivalent to selecting the measurement in the Select MeasureĆ
ment side menu.
Measurement
MEASUrement:MEAS<x>:TYPe { AMPLitude | BURst | CMEan |
CRMs | FALL | FREQuency | HIGH | LOW | MAXimum | MEAN
| MINImum | NDUTy | NOVershoot | NWIdth | PDUTy |
PERIod | PK2pk | POVershoot | PWIdth | RISe | RMS }
MEASUrement:MEAS<x>:TYPe?
Group:
Syntax:
Arguments:
Examples:
Group:
Syntax: