Filter
Top Products
Reference
TDS1000/2000-Series Digital Oscilloscope User Manual
97
Save/Recall
Push the SAVE/RECALL button to save or recall oscilloscope setups
or waveforms.
Setups
Options Settings Comments
Setups Highlighting Setups displays the menus
for storing or recalling oscilloscope setups
Setup 1to10 Specifies the memory location in which to
save the current oscilloscope settings or
from which to recall the settings
Save Completes the save action
Recall Recalls the oscilloscope settings stored in
the location chosen in the Setup field
Key Points
Saving and Recalling Setups. The complete setup is stored in
nonvolatile memory. When you recall the setup, the oscilloscope will
be in the mode from which the setup was saved.
The oscilloscope saves the current setup if you wait three seconds
after the last change before you power off the oscilloscope. The
oscilloscope then recalls this setup the next time you apply power.
Recalling the Default Setup. You can push the DEFAULT SETUP
button to initialize the oscilloscope to a known setup. To view option
and control settings that the oscilloscope recalls when you push this
button, refer to Appendix D: Default Setup on page 175.