Filter
Top Products
10
ASSEMBLY INSTRUCTIONS (Continued)
LEVEL BASE
Place a level on the top of the table and check the
unit for level side to side. Adjust the leveling feet as
necessary until the machine is level.
See FIG. 3 and 4.
Place a level across the table from front to rear.
Adjust the leveling feet as necessary until the
machine is level. See FIG. 3 and 5.
When both front to back and side to side leveling
procedures have been completed, thread the hex
jam nuts up against the nut that is welded to the
bottom of the machine. Be careful not to move the
leveling feet during when tightening the jam nut. See
FIG. 3. Make certain that all four leveling feet are
firmly contacting the floor.
Recheck that the machine is level after locking the
four feet into position.
FIG. 5
FIG. 4
FIG. 3
LEVELING FEET LOCATED
AT CORNERS OF MAHCINE
LOOSEN JAM NUT TO
ADJUST FOOT