Filter
Top Products
6
TABLE OF CONTENTS
TABLE OF CONTENTS
Safety Instructions ................................................................................................................. Page 2-6
Daily Maintenance .................................................................................................................. Page 6
Service Data .......................................................................................................................... Page 7
Assembly Instructions ............................................................................................................ Page 8-12
Maintenance .......................................................................................................................... Page 13-19
Adjustments........................................................................................................................... Page 20-25
Electrical Troubleshooting...................................................................................................... Page 26-41
Mechanical Troubleshooting .................................................................................................. Page 42-43
Exploded Views and parts Lists ............................................................................................. Page 44-71
Wiring Diagram & Schematic ................................................................................................ Page 72-74
DO NOT USE COMPRESSED AIR TO CLEAN
GRINDING DUST FROM GRINDER
Low Voltage Relay
This machine is intended for grinding the reel of reel type mower units ONLY.
Any use other than this may cause personal injury and void the warranty.
To assure the quality and safety of your machine and to maintain the warranty,
you MUST use original equipment manufactur's replacement parts and have
any repair work done by a qualified professional.
ALL operators of this equipment must be thoroughly trained BEFORE operating
the equipment.
Do not use compressed air to clean grinding dust from the machine. This dust
can cause personal injury as well as damage to the grinder. Machine is for
indoor use only. Do not use a power washer to clean the machine.
DAILY MAINTENANCE BY THE OPERATOR
On a daily basis, clean the machine by wiping it off.
On a daily basis, remove all grinding grit from the grinding shaft, traverse shafts, and tooling
bar area.
On a daily basis, inspect the machine for loose fasteners or components.
Contact your company's Maintenance Department if damaged or defective parts are found.
The grinder is equipped with a high-low voltage relay
which is factory preset at 100-140 VAC. If the power
supply line does not deliver 100-140 VAC power under
load, the relay will open and trip out the starter. If this
occurs, your power supply line is incorrect and must be
corrected before proceeding further with the grinder.