HP (Hewlett-Packard) HP 16555A Weather Radio User Manual


 
To configure a single-card module
When shipped separately, the module is configured as a single-card
module. The cables should be connected as shown in the figure.
To configure a multi-card module into single-card modules, remove the
cables connecting the cards. then connect the free end of the 2x10 cable
on the connector labeled "Master" (J6) on each card (see figure below).
CAUTION
If you pull on the flexible ribbon part of the 2x10 cable, you might damage
the cable assembly. Using your thumb and finger, grasp the ends of the
cable connector. Apply pressure to the ends of the cable connector to
disengage the metal locking tabs of the connector form the cable socket on
the board. Then pull the connector from the cable socket.
Save unused cables for future configurations.
Installation
To configure a single-card module
14–2