Filter
Top Products
Overlay
The Overlay mode inserts all bits of a label in a single waveform to form a
composite waveform label. The onscreen indication for the Overlay mode is
"All" following the label name.
Viewing State Data in Overlay Mode
When all assigned waveforms in a label are overlaid, the value of the data is
displayed to the right of each new transition in the waveform display.
If the sec/Div is set to view a large increment of time, or the waveform scaling
is set to small or medium, the state data readout will not fit between
transitions. To display the state data readouts within the waveform, expand
the sec/Div and use the large waveform setting. If symbols are assigned to
represent data values, the symbol is displayed.
Module and Label Fields
If there are multiple timing analyzer or oscilloscope modules installed in the
mainframe, this field will appear in the menu, and waveforms from the other
modules can be displayed in the waveform menu. The Module field accesses
a selection list. This list contains the modules installed in the mainframe that
are configured in a Group Run, and that have timing or oscilloscope
waveforms.
The Waveform Menu
Module and Label Fields
7–27