Filter
Top Products
Data Entry/Display
Labels
Channels may be grouped together and given a 6-character name.
Up to 126 labels in each analyzer may be assigned with up to 32 channels per
label.
Display Modes
State listing, State Waveforms, Timing Waveforms, Timing
Listings, Compare Listings, Chart, and System Performance Analysis. State
Listing, Timing Waveforms, and Oscilloscope Waveforms can be
time-correlated on the same displays.
Timing Waveform
Pattern readout of timing waveforms at X or 0 marker.
Bases
Binary, Octal, Decimal, Hexadecimal, ASCII (display only), Two’s
Complement, and User-defined symbols.
Symbols
500 maximum. Symbols can be downloaded over RS-232, HP-IB,
or Ethernet LAN.
Marker Functions
Time Interval
The X and 0 markers measure the time interval between one
point on a timing waveform and trigger, two points on the same timing
waveform, two points on different waveforms, or two states (time tagging
on).
Delta States (state analyzer only)
The X and 0 markers measure the
number of tagged states between one state and trigger or between two states.
Patterns
The X and 0 markers can be used to locate the nth occurrence of a
specified pattern from trigger, or from the beginning of data. The 0 marker
can also find the nth occurrence of a pattern from the X marker.
Statistics
X and 0 marker statistics are calculated for repetitive
acquisitions. Patterns must be specified for both markers, and statistics are
kept only when both patterns can be found in an acquisition. Statistics are
minimum X to 0 time, maximum X to 0 time, average X to 0 time, and ratio of
valid runs to total runs.
Specifications and Characteristics
Supplemental Characteristics
13–8