Filter
Top Products
Using SPA with other features
Programming with SPA
SPA is programmable. Refer to the appropriate Programmer’s Guide for
SPA commands. The Programmer’s Guide is available as an option with the
logic analyzer. Contact your HP Sales Office for more information.
Changing between SPA and a State/Timing Analyzer
If you have configured a state or timing analyzer in the logic analyzer, you
can quickly change to SPA, or from SPA to a state or timing analyzer. You can
use the same Format menu in your SPA measurements as you did in your
state or timing analysis measurements.
To change between a state analyzer and SPA, go to the Configuration menu,
select the Type field, and select SPA from the list.
When SPA is selected, a separate trace specification definition is used. Even
though the Qualified State Histogram and Time Interval modes use the same
pattern recognizers as the state and timing analyzers, the SPA definitions are
kept separate from those entered in the state or timing analyzer mode. As a
result, switching between SPA and state or timing recovers the user’s original
pattern recognizers for the selected mode.
Any Symbols in the Format menu will also carry over to SPA.
The SPA Menu
Using SPA with other features
11-30