2
Getting Set Up
2-8
Phaser 350 Color Printer
Warning
The printer is not permanently attached to the Lower Paper
Tray Assembly. When moving the printer, first disconnect it
from the Lower Paper Tray Assembly and then move each unit
separately. Moving the printer incorrectly may cause damage
or personal injury.
The printer weighs about 32 kg (70 lbs.). Do not attempt to lift
the printer without the assistance of another person.
Install the Lower Paper Tray Assembly using these steps:
1.
Remove the tray from the Lower Paper Tray Assembly. Remove
the shipping block from the tray and replace the tray in the Lower
Paper Tray Assembly.
2.
Place the printer on top of the Lower Paper Tray Assembly.
Note
To ensure proper printer operation, install the printer and Lower
Paper Tray Assembly on a flat surface having no more than 3
degrees of tilt. This is approximately equivalent to lifting one side
of the printer 2 cm (0.75 inches) off of a flat surface.
9101-57
