User Manual
2-1
Chapter
2
Getting Set Up
At a glance
Installation of your printer involves these tasks:
1.
Setting up the printer (page 2-2).
Putting all the pieces together: unpacking the printer and accessories,
installing the optional Lower Paper Tray Assembly, installing the
optional Phaser CopyStation, loading the media tray(s), loading ink
sticks, and installing the maintenance tray.
Note
For instructions on installing a SCSI hard disk for font storage
and print collation, refer to the printer’s CD-ROM.
2.
Connecting the power and interface cables (page 2-20).
3.
Selecting a language for the front panel (page 2-28).
4.
Installing printer driver software on your computer (page 2-30).
Using the Printer Software diskettes or the printer’s CD-ROM
to install software, for example, drivers, PostScript Printer
Description (PPD) files and utility files, on a Macintosh, or a PC
running Windows 95, Windows 3.1, or Windows NT.
Caution
To ensure proper printer operation, install the printer on a flat
surface having no more than 3 degrees of tilt. This is
approximately equivalent to lifting one side of the printer 2 cm
(0.75 inches) off of a flat surface.
