Radio PC Card Configuration 2-31
MX2A137REFGD Revision A MX2 Reference Guide
Link Driver RL2PCM
Socket A
Initialize_365 N
Int 3
Mem #1 C100
Port 300
Inactivity_Min 0
Inactivity_Sec 1
Sniff_Time 0
Domain 0
Station_Type 0
Peer_To_Peer N
Roam_Config 1
Mac_Optimize 1
Channel 1
SubChannel 1
Frame Ethernet_II
Frame Ethernet_802.2
Frame Ethernet_802.3
DOS Configuration
Parameters
Configuration parameters for DOS can be contained in the NET.CFG
or
PROTOCOL.INI file. You can use an ASCII text editor to add or
modify parameters in those files, or you can edit them using the Text
File button in the third File Configuration window of the Configuration
Utility. The modifiable parameters are described in the following table.
DOS Parameters
Note: Hex values are indicated with a leading 0x. NET.CFG values
do not use the 0x; PROTOCOL.INI values require the 0x.
Keyword Description
Int Sets the interrupt (IRQ) line to be used. This must be
set to 3, which is the only free interrupt.
Port Sets the I/O port address. The default is 0x300.
Mem#1 (ODI)
Memory_address (NDIS)
Sets the resource memory location (0xC000 to
0xE800). Upper memory blocks from 0xA000 to
0xCFFF are used by MX2 system software. Memory
from 0xD000 to 0xDFFF is reserved for PC card
client drivers. Since card services use 0xD000, onl
