7-4 The Single Dock
MX2 Reference Guide Revision A MX2A137REFGD
The Power Adapter
Important: The MX2 is not designed to use alkaline or non-
rechargeable batteries.
Figure 7-3 US Dock Power Adapter
You can use a 9-volt power adapter with the Single Dock to recharge the
batteries in the MX2. Power adapters are available from LXE.
Attach the small, round plug of the power adapter to the power input
jack on the back of the Single Dock. Plug the other end into an AC
outlet or power strip. The red light-emitting diode (LED) labeled
POWER on the front panel of the Single Dock should light up.
The power adapter is used only to recharge the batteries in the MX2.
However, if you do not use it, the LED indicators on the Single Dock
will not light up. (The READY light indicates that the MX2 is properly
inserted in the dock. The READY light will appear red when charging
MX2 batteries and green when batteries are fully charged.)
Note: Use only a 9-volt power adapter supplied by LXE. Using
another adapter can damage the dock.
