B-2 Parameters, Settings, and Defaults
MX2 Reference Guide Revision A MX2A137REFGD
and also identifies the symbology of each barcode you
scan.
Predefined Default 2 (D2)
is the default set that was
installed in the MX2 at the factory. This default set will
work for most applications. If you have changed any
settings and want to reset the MX2 to the original defaults,
scan the
D2
barcode in Appendix C.
Parameters, Settings, and Defaults
Enter 1 for On and 0 for Off.
Code 39
Defaults
Code Parameters I.D. # Type Acceptable Input D0 D1 D2
Enable 00 On/Off On
or
Off Off On On
Minimum length 01 Value 00–50 00 00 00
Maximum length 02 Value 01–50 01 50 20
Enable checksum 03 On/Off On
or
Off Off Off Off
Send checksum 04 On/Off On
or
Off Off Off Off
Full ASCII mode 05 On/Off On
or
Off Off On On
