LXE MX2A137REFGD Manual

A SERVICE OF

next previous

7-6 The Single Dock

MX2 Reference Guide Revision A MX2A137REFGD

When you execute the XFER command on the host, XFER will transfer

the file from the host to the MX2.

Note: Xmodem uses no flow control, by default. For Zmodem, the

default flow control is RTS/CTS. To use XFER with Zmodem

with the Dock, hardware flow control must be turned off using

the appropriate XFER command line switch, and XON/XOFF

flow control should be used instead. This holds true for any

communications software on a MX2 using the Dock.

See Chapter 4 “Configuration Utility” or Chapter 5 “Using XFER.”