MX2A137REFGD Revision A MX2 Reference Guide
Appendix C
Barcodes for Configuring MX2
Introduction
This appendix provides barcodes for common setup parameters for
programming the MX2. Factory default settings are listed in the section
titled “Default Settings” and are included
as part of the parameter
heading.
To make settings that aren’t provided here, you can use your own
barcodes. Using the barcodes contained in this section, you can change
any scanning system parameter or reset all parameters to their default
values. This chapter contains Code 39 barcode symbols for system setup
parameters.
Refer to the MX2 Installation and Operator’s Guide (LXE DocID
MX2A136OPGDWW) for the section titled “Scanner Warnings and
Labels” for important laser safety information
before
using the scanner.
When scanning the barcodes in this section, remember:
•
Do not look into the laser’s lens.
•
Do not stare directly into the laser beam.
•
Do not remove the laser caution labels from the MX2.
How To
Select the symbol parameter you want to scan. Lay this reference guide
flat on a table or propped up.
Holding the scanner approximately 6 - 12 inches away from the symbol,
scan the selected symbol.
When the Scan LED illuminates, the parameter has been decoded.
Note: Whether there are beeps in conjunction with scan and decode
functions is dependent on the application currently running in
the MX2. For example, the ANSI Plus terminal emulator
program emits one beep when a barcode is scanned and
decoded successfully.
