Filter
Top Products
Greensmaster eFlex 1800/2100Page 4 -- 32Electrical System
Traction Switch
1. Traction switch
2. Engagement lever assembly
3. Lower handle
4. Washer head screw (2 used)
5. Lock nut (2 used)
6. Console cover
7. Washer head screw (4 used)
8. Switch mount bracket
Figure 40
FRONT
RIGHT
5
3
1
2
6
4
7
8
The traction switch is a normally open proximity switch.
This switch is one of several inputs for the TEC control-
ler.Theswitchisattachedtothehandleassemblyswitch
mount bracket (Fig. 41).
When the traction engagement lever isnot engaged, the
head of the cap screw in the traction lever is positioned
away from the target end of the traction switch so the
switch is in its normal open state. The head of the cap
screw in the traction engagement lever is moved toward
the switch target when the traction lever is engaged
causing the switch to close.
CheckTractionSwitchOperation
Check traction switch operation with the InfoCenter on
the console. With the key switch in the RUN position and
the InfoCenter in the Diagnostics menu, choose Trac-
tion and make sure that the switch state changes as the
traction lever is applied and released. Further traction
switch testing is necessary only if the switch state does
not change when using the InfoCenter.