Filter
Top Products
Greensmaster eFlex 1800/2100Traction and Reel Drive System Page 3 -- 32
Transmission Reel Drive System
Figure 39
1. Transmission housing
2. Flex coupler
3. Hex shaft
4. Spring pin (2 used)
5. Retaining ring
6. Plug
7. Retaining ring (reel clutch cable)
8. Flange bushing (2 used)
9. Flange bushing (2 used)
10. Reel clutch lever
11. Reel brake ring
12. Ball bearing
13. Retaining ring
14. Reel brake disc
15. Clutch pivot pin (2 used)
16. Reel clutch fork
17. Reel clutch hub
18. Reel drive hub
19. Clutch shaft
20. Spacer
21. Ball bearing (2 used)
22. Reel clutch pulley
23. Bearing collar
24. Flocked bearing shield
25. Wave spring
26. Flat washer
27. Retaining ring
28. Ball bearing
FRONT
RIGHT
23 to 27 ft--lb
(32to36N--m)
7
8
9
10
11
12
13
14
15
16
17
18
19
20
22
23
24
25
26
27
28
5
15
8
21
9
1
6
2
3
4
Indicator
Mark
Loctite #242
Loctite #242
Transmission removal from the machine is not neces-
sary to service the transmission reel drive system.
Transmission reel drive components can be accessed
by removing the battery pack from the frame, removing
the transmission cover andthen removing the drive belt.
Reel Clutch Shaft Removal (Fig. 39)
1. Parkmachineon level surface. Turnkeyswitch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
the General Information section of this chapter).
2. Disconnect reel clutch cable from transmission (see
Reel Clutch Cable Replacement in the Service and Re-
pairs section of Chapter 6 -- Chassis and Controls).
3. Remove transmission drive belt (see Transmission
Drive Belt in this section).
4. Remove retaining ring (item 5) that secures reel
clutch lever (item 10) in transmission housing. Slide reel
clutch lever from housing. Note missing tooth in spline
area of lever which is used for alignment with reel clutch
fork (item 16).
5. Pull reel clutch shaft assembly from transmission
housing. NOTE: If ball bearing (item 28) on reel clutch
shaft assembly is seized in housing, refer to Removing
Seized Reel Clutch Shaft FromTransmissionin this sec-
tion for removal procedure.