Filter
Top Products
Greensmaster eFlex 1800/2100Traction and Reel Drive System Page 3 -- 22
7. Slide lock collar (item 27) onto drum shaft. Align
holes in collar and shaft and then install pin (item 28). Fit
O--ring (item 30) to slot in collar.
8. If grease seal (item 12) was removed from LH trac-
tion drum, install new grease seal into drum. Make sure
that seal lip is orientated toward center of drum. Press
seal into drum bore so that seal is recessed from 0.470”
to0.530”(12.0to 13.4 mm) from edge of drum (Fig. 26).
9. Place square key (item 6) into slot of drum shaft. Ap-
ply antiseize lubricant to top surface of key.
10.Align slot in LH traction drum ( item 13) with key on
drum shaft and carefully slide traction drum onto shaft
taking care to not damage grease seal in drum.
11.Insert bar stock or other suitable t ool through spokes
of LH traction drum to keep drum from turning.
12.Make sure that ball bearing (item 14) is pressed onto
the bearing nut (item 15). While retaining LH drum, se-
cure drum to traction drum assembly with bearing nut
(item 15). Torque bearing nut from 75 to 90 ft--lb (102
to 122 N--m).
13.Secure LH side plate (item 25) to machine (Fig. 25):
A. Slide LH side plate onto supporting bearing.
B. Secure LH side plate to frame with three (3)
flange screws and hardened washers.
C. Secure LH side plate to rear frame with carriage
screw, hardened washer and flange nut.
14.Install handle assembly to machine (see Handle As-
sembly in the Service and Repairs section of Chapter 6
-- Chassis andControls). Makesure thatall cable adjust-
ments are correct.
15.Install transport wheels if necessary (see Transport
Wheels in the Service and Repairs section of Chapter 6
-- Chassis and Controls).
16.Connect the battery pack(see Battery PackConnec-
tion in the General Information section of this chapter).