Filter
Top Products
Greensmaster eFlex 1800/2100Traction and Reel Drive System Page 3 -- 16
Drum Drive Belt
1. Drum drive cover
2. Washer head screw (7 used)
3. Gasket
4. Wave washer
5. Gear assembly
6. Retaining ring
7. Brake band
8. Brake mount pin
9. Extension spring
10. Drum drive belt
11. Brake clevis pin
12. Drum drive housing
13. Retaining ring
14. Idler pulley assembly
15. Shoulder screw
16. Idler arm assembly
17. Washer head screw (4 used)
18. Drive pulley (from transmission)
Figure 19
5
13
11
4
10
17
7
12
16
3
8
2
14
15
2
18
9
1
6
See text for
tightening
procedure
15 to 17 ft--lb
(21to23N--m)
The drum drive system on eFlex 1800 and eFlex 2100
machines uses a multi--ribbed poly--V drive belt on the
right side of the traction drum.
Removal (Fig. 19)
1. Parkmachineon level surface. Turnkeyswitch to the
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
the General Information section of this chapter).
2. Remove transport wheels if attached (see Transport
Wheels in the Service and Repairs section of Chapter 6
-- Chassis and Controls).
3. Rotate traction engage/disengage leverto the disen-
gaged position t o remove tension from the drum drive
belt (Fig. 20) (see Disengaging Drum Drive From Trans-
mission in the General Information section of this chap-
ter).
4. Remove seven (7) washer head screws that secure
the drum drive cover. Remove cover to expose the trac-
tion drive belt.
5. Remove and discard gasket (item 3) from between
cover and housing.