Filter
Top Products
Greensmaster eFlex 1800/2100Groomer Page 7 -- 12
NOTE: To prevent cutting reel from turning when instal-
ling drive pulley, use a 1/2” socket on hex of reel d rive
shaft that is used for backlapping the cutting reel.
9. Secure drive pulley (item 4) to cutting reel shaft.
Torque pulley to 100 ft--lb (135 N--m).
10.Insert front roller into LH groomer arm assembly.
11.Make sure that bushing (item 11) is installed in drive
plate assembly.
12.Apply antiseize lubricant to threads of RH groomer
arm lift rod.
13.Position RH groomer arm assembly to front roller,
RH drive plate assembly and cutting unit frame. Secure
groomerarm to cutting unit withplowbolt ( item 22),HOC
washer (item 16) and HOC nut (item 2 1).
14.Secure RH groomer armassembly to drive plate with
spring washer (item 12) and lock nut (item 13).
15.Center front roller to cutting unit and tighten cap
screws (item 10) to secure roller.
16.Install groomer drive belt (item 3) and groomer drive
cover (item 2) to RH drive plate (see Groomer Belt Re-
placement i n this section).
17.Check grooming reel height and mower height--of--
cut settings. Adjust as needed.
18.Install cutting unit to the machine.
19.Lubricate groomer bearings (see Groomer Installa-
tion Instructions).
20.Connect the battery pack(see Battery PackConnec-
tion in the General Information section of this chapter).
NOTE: After greasing groomer bearings, operate
groomer for 30 seconds, stop machine and wipe excess
grease from groomer shaft and seals.