Filter
Top Products
Greensmaster eFlex 1800/2100Page 6 -- 12Cutting Unit
Bedbar Assembly
1. Bedbar
2. Bedknife
3. Screw (13 used)
4. Bedbar adjuster screw (2 used)
5. Bedbar adjuster shaft (2 used)
6. Cap screw (2 used)
7. Detent (2 used)
8. Wave washer (2 used)
9. Retaining ring (2 used)
10. Lock nut (2 used)
11. Washer (2 used)
12. Compression spring (2 used)
13. Lock nut (2 used)
14. Rubber bushing (2 used)
15. Nylon bushing (2 used)
16. Plastic washer (4 used)
17. Metal washer (4 used)
18. Bedbar pivot bolt (2 used)
Figure 17
FRONT
RIGHT
200 to 250 in--lb
(23to28N--m)
Antiseize
Lubricant
1
17
16
18
10
14
15
16
17
7
4
13
6
11
12
8
9
2
3
5
190 to 240 in--lb
(22to27N--m)
eFlex 2100 Shown
Bedbar Removal (Fig. 17)
1. Parkmachineon level surface. Turnkeyswitch to the
OFF position and remove key from the switch. Make
sure the traction lever is in the NEUTRAL position.
2. Disconnect the battery pack (see Battery Pack Con-
nection in the General Information section of this chap-
ter).
3. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
4. Tip the cutting unit to expose the bedknife. Support
the rear of the cutting unit ( see Supporting Cutting Unit
when Servicing in the General Information section of
this chapter).
5. Loosen the lock nuts (item 13) on the end of each
bedbar adjuster assembly until washer (item 11) is
loose.
6. Loosen the lock nuts (item 10) on each bedbar pivot
bolt (item 18).