Filter
Top Products
Greensmaster eFlex 1800/2100 Traction and Reel Drive SystemPage 3 -- 9
Reel Clutch Adjustment
To adjust the reel clutch, follow the following steps:
1. Parkmachineonlevelsurface.Turnkeyswitchtothe
OFF position and remove key from the switch. Discon-
nect the battery pack (see Battery Pack Connection in
the General Information section of this chapter).
2. Remove rubber plug from front of transmission to al-
low viewing of reel drive clutch components (Fig. 1 2).
3. Release clutch cable spring tension byremoving reel
clutch cable from casting slot of transmission:
A. Loosen upper jam nut that secures reel cable to
casting slot of transmission.
B. Lift cable free from casting slot of transmission.
4. Loosen jam nut that secures set screw position in
reel clutch lever (Fig. 12).
5. Apply light upward pressure against the reel clutch
lever.
6. Backout set screwin reel clutch leveruntil reel clutch
hub causes the tips of the reel drive hub teeth to contact
the mating reel clutch pulley.
7. While maintaining light pressure on reel clutch lever,
rotate set screw clockwise until a gap of 0.040” to
0.060”(1.0to1.5mm)is attained betweenthe reel drive
hub and reel clutch hub.
8. Tighten jam nut t o secure a djustment. Make sure
that set screw does not rotate while tightening jam nut.
9. Install rubber plug into front of transmission.
10.Install reel cable to casting slot of transmission and
confirm that cablespring length isproperly set (see Reel
Clutch Cable Replacement in Chapter 5 -- Chassis and
Controls).
11.Connect thebattery pack (see Battery PackConnec-
tion in the General Information section of this chapter).
1. Reel drive hub tooth
2. Reel drive hub
3. Reel clutch hub
4. Reel clutch lever
5. Set screw
6. Jam nut
7. Gap location
Figure 12
3
12
6
5
4
0.040” to 0.060”
(1.0 to 1.5 mm)
Light Upward
Pressure
7
1. Reel clutch lever
2. Reel clutch hub
3. Reel drive hub
4. Reel clutch pulley
Figure 13
4
3
2
1
Traction and Reel
Drive System