Filter
Top Products
Greensmaster eFlex 1800/2100 Page 5 -- 17 Chassis and Controls
Wheel Removal (Fig. 17)
1. Parkmachineonlevelsurface.Turnkeyswitchtothe
OFF position and remove key from the switch.
2. Support the machine on the kickstand.
3. Pivot wheel retaining lever away from the center of
the wheel. Slide transport wheel off the wheel hex shaft.
Wheel Disassembly (Fig. 16)
1. Make sure that tire is fully deflated before disassem-
bly of wheel.
2. Remove three (3) cap screws and lock washers from
the shallow rim and hub. Remove hub from deep rim.
3. Inspect hub bushing (item 12). If worn or damaged,
replace bushing.
4. Remove four (4) cap screws and flangenuts from the
deep rim and shallow rim. Remove shallow rim from the
deep rim.
5. Separate tire, tube and deep rim.
6. Ifnecessary, remove shoulder screws, torsion spring
and retaining lever from the hub.
Wheel Assembly (Fig. 16)
1. If shoulder screws were removed from hub, apply
Loctite #242 (or equivalent) to threads of shoulder
screws. Secure torsion spring and retaining lever to the
hub with shoulder screws.
2. Assemble tire, tube and deep rim.
3. Install shallow riminto the tire. Align and secure shal-
low rim to the deep rim with four (4) cap screws and
flange nuts. Tighten fasteners.
4. Installhub into deep rim. Secure hub to deeprim with
three (3) cap screws and lock washers. Tighten fasten-
ers.
5. Inflatetirefrom12to15PSI(83to103kPa).
Wheel Installation (Fig. 17)
1. Make sure machine is parked on a level surface and
thekeyisremovedfromthekeyswitch.
2. Support the machine on the kick stand.
3. Slide transport wheel completely onto the wheel hex
shaft until the wheel retaining lever is secured into the
groove on the wheel hex shaft.
1. Wheel retaining lever 2. Wheel hex shaft
Figure 17
1
2
1. Wheel hex shaft
Figure 18
1
Chassis and
Controls