Filter
Top Products
APPENDIX A-3: Warnings and Test Functions, Revision K.6 M300EU Addendum to M300E/EM Manual
Table A-5: Additional or Changed Test Function Relevant to the M300EU , Revision K.6
TEST FUNCTION
NAME
MESSAGE TEXT DESCRIPTION
STABILITY STABIL=0.0 PPM
These gases not applicable to the M300EU
AUTOZERO AZERO RATIO=1.234
Measure/reference ratio during auto-reference.
BOXTEMP2 BOX TEMP2=29.6 C
Internal box temperature #2.
OVENTEMP OVEN TEMP=30.1 C
Oven temperature
Table A-6: M300E/EM Test Function Not Applicable to the M300EU, Revision K.6
Because the CO
2
and O
2
sensor options are not available on the M300EU, the following test functions listed in
Appendix A-2 of the M300E/EM Operators Manual (P/N 04288) are not present in the M300EU software.
TEST FUNCTION
NAME
MESSAGE TEXT DESCRIPTION
CO2RANGE CO2 RANGE=20 %
1
CO
2
range.
O2RANGE O2 RANGE=100 %
2
O
2
range.
[STABILITY]
CO STB=0.0 PPM
1, 2
CO2 STB=0.0 %
1
O2 STB=0.0 %
2
These gases not applicable to the M300EU
O2CELLTEMP O2 CELL TEMP=50.2 C
O
2
sensor cell temperature.
CO2SLOPE CO2 SLOPE=1.000
CO
2
slope, computed during zero/span calibration.
CO2OFFSET CO2 OFFSET=0.000
CO
2
offset, computed during zero/span calibration.
O2SLOPE O2 SLOPE=0.980
O
2
slope, computed during zero/span calibration.
O2OFFSET O2 OFFSET=1.79 %
O
2
offset, computed during zero/span calibration.
A-12 05924 Rev K.6