Filter
Top Products
M300EU M300EU OPERATING INSTRUCTIONS
(Addendum to M300EU Manual - P/N 04145)
6.3.3. RNGE Æ MODE Æ SNGL: CONFIGURING THE M300EU ANALYZER
FOR SINGLE RANGE MODE
The single range mode sets a single maximum range for the both the A1 and A2 analog outputs. If the single
range is selected both outputs are slaved together and will represent the same reporting range span (e.g. 0-50
ppm), however their electronic signal levels may be configured for different ranges (e.g. 0-10 VDC vs. 0-.1 VDC.
This Reporting range can be set to any value between 0.1 ppb and 10,000 ppb. To select SINGLE range mode
and set the upper limit of the reporting range, press:
NOTE
This is the default reporting range mode for the analyzer.
05514 Rev A1 25