Filter
Top Products
Chapter 5. Programming keypad
When changing run frequency to 30.05 Hz in Drive group
Drive group
1
-. In “0.0”, press the Prog/Ent (z) key once.
2
-. The second 0 in 0.0 is active.
-. Press the Right (X) key once to move the cursor to the right.
3
-. 0.00 is displayed
-. Press the Up (S) key until 5 is displayed.
4
-. Press the Left (W) key once.
5
-. The middle digit in 0.05 is active.
-. Press the Left (W) key once.
6
-. Press the Left (W) key once.
7
-. 00.0 is displayed with the first 0 active, but the actual value 0.05 remains
unchanged.
-. Press the Up (S) key to set to 3.
8
-. Press the Prog/Ent (z) key once.
-. 30.0 is blinking.
-. Press the Prog/Ent (z) key once.
9
-. Run frequency is set to 30.0 when the blinking stops.
♣ Three digit LED display is provided. However, digit expansion is available using the
Left(W)/Right(X) key for parameter setting and monitoring.
♣ In step 8, pressing the Left (W) or Right (X) key while 30.0 is blinking will disable the
setting.
32