Filter
Top Products
54
Section 7: Features & Benefits
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
12/15/15
Table of Contents
Section 7: Features & Benefits
RCF(M)3696 & RCF(M)3610 Models
Features Benefits
Surpassed rugged
industry standards
All Land Pride Cutters have been designed and tested and meet rigorous voluntary testing
procedures.
540 or 1000 RPM Fits wider variety of tractors.
High Gearbox HP rating Gearboxes are built rugged. See Specifications for actual Gearbox HP ratings.
5 Yr. limited gearbox warranty Shows our confidence in the gearbox integrity.
3 Gearboxes Allows equal torque to be spread to left and right gearbox.
Splined rubber flex-couplers
between the center and
outboard gearboxes
Protects the driveline and gearboxes from hard objects in the blade path.
Pull-Type constant velocity
driveline Option
Constant velocity driveline reduces chatter and extends life of U-joint during turns.
Slip-clutch protection
on main driveline
Slip-clutch is more convenient than shear-bolt, protects gearbox against sudden impact.
8'- Cat. 1 & 2 or 10'- Cat. 2 & 3
3-Point & Semi-Mount Hitches
or Pull-Type Hitch
Fits a wide range of tractors.
Semi-Mount and Pull-Type fit older tractors without a top link and smaller tractors without
enough lift capacity.
10 Gauge deck, fully welded Fully welded deck adds rigidity.
1/4" Thick sidewalls Protects sidewalls from thrown objects.
Round back design
Allows for cleaner and efficient discharge of material, helps eliminate damage to rear
corners by not sticking out.
Pull-Type w/dual leveling rods Dual leveling rods eliminate deck twisting when going over uneven terrain.
Chain or rubber guard option Reduces flying debris.
Full length skids
with replaceable shoes
Adds reinforcement to side panels. Replaceable shoes allow for change before wearing
through to weld-on piece.
Splined blade hub Splined blade hub offers tight non-slipping attachment to output shaft.
3/16" Round stump jumper
Standard stump jumper aids in sliding over obstructions, which helps protect gearbox
output shaft.
1" x 5" Blade bar Heavy-duty blade bar adds support to stump jumper as well as gearbox output shaft.
1/2" x 4" Heat-treated blades Heat-treated blades last longer than non-heat-treated blades.
3" Diameter cutting capacity Aids in cutting brush.
High blade tip speed Means cleaner cutting. See Specifications for actual blade tip speeds.
Laminated tires Laminated tires can handle almost any condition and don’t go flat.
Quick Hitch adaptable 3-Point and semi-mount are Quick Hitch adaptable.
Paint Options Choice of red, orange, green, or beige to match popular tractor lines.