Filter
Top Products
46
Section 5: Maintenance & Lubrication
RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M
12/15/15
Table of Contents
Refer to Figure 5-5:
Progressively tighten each spring retainer bolt until
correct spring height “A” is reached.
Clutch Adjustment
Figure 5-5
RCF(M)3696
RCF(M)3610
Driveline
No.
Driveline
Location
PTO
Speed
Cat
No.
A (inches)
Spring Height
826-255C
826-256C
Main
Jack Shaft
540 4 1.18"
826-258C
826-259C
Main
Jack Shaft
1000 4 1.09"
Driveline
No.
Driveline
Location
PTO
Speed
Cat
No.
A (inches)
Spring Height
826-215C
826-220C
826-225C
Main
Jack Shaft
Stub Shaft
540 4
1. 1 8 "
826-216C
826-221C
826-226C
Main
Jack Shaft
Stub Shaft
1000 4
1.09"
24600
Flex Couplers
Figure 5-6
Flex Couplers
Refer to Figure 5-6:
Replace two rubber discs (#1), (Land Pride Part No.
1785273), as follows: If additional repair parts are
required, refer to Land Pride’s Parts Manuals 326-600P
for RCF(M)3696 and 326-423P for RCF(M)3610 cutters.
1. Insert three bolts (#3) through the holes in flange
weldment (#7).
2. Place beaded washers (#2) over the three bolts with
bead facing rubber disc (#1).
3. Place bushings (#6), rubber disc (#1), washers (#5),
2nd rubber disc (#1), 2nd bushing (#6) and 2nd
washer (5) over the three bolts as shown.
4. Secure with nuts (#4). Do not tighten.
5. Insert three bolts (#3) through holes in flanged
hub (#8).
6. Repeat steps 2 through 4.
7. Tighten nuts (#4) evenly with nuts torqued
35 to 40 ft-lb. Beaded washers (#2) should be
embedded halfway into the rubber disc.
14560